CBC-2 Internal Thermal Barrier Coatings

• Finish: Aluminum-like
• Thermal Barrier
• Adhesion to 700F (1000F intermittent)
• Water Based
• Curing: 350F for 1 hour.

FOR USE ON: PISTONS COMBUSTION CHAMBERS VALVES PORTS 3oz will cover approx. 24 4 inch round pistons Stir and Shake before use All parts must be clean of all oils, dirt, or other debris. Water-based no hazardous fumes, nonflammable. Blast lightly with 120 grit aluminum oxide at low pressure. Degrease with a nonpetroleum-based solvent. After STIRRING and shaking ( mix in a blender) then apply the coating. Spray at an air pressure of about 60 psi through a fine nozzle ( 1mm or less). Allow drying to a gray/white finish. Bake at a minimum of 350f for 1 hour. Inspect part after curing for blisters, cracking, or flaking. Reduces part temperature. Keeps heat in the combustion chamber longer, through the power stroke. Reduce fuel consumption. DO NOT ASSEMBLE IF DAMAGE VISIBLE Polish with 0000 steel wool and a polishing compound. Water-Based Paint Use Water For Cleanup DANGER: Contains aluminum powder and phosphate /chromic solution. Contact with soaps or strong alkalis may produce hydrogen gas causing fire or explosion hazards. DO NOT use water to extinguish the fire. Danger: Do not breathe vapors or mists from spraying. Avoid contact with skin and eyes. Use adequate ventilation to maintain exposure levels below established exposure limits (see MSDS). If required wear an appropriate NIOSH-approved respirator with a paint prefilter. FIRST AID: Skin- Flush with water. Eyes-Flush with plenty of water. IF SWALLOWED- Drink plenty of water and milk of magnesia and GET MEDICAL ATTENTION EMERGENCY 1-800-535-5053

WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov