Barrier Coatings

FOR: PISTONS COMBUSTION CHAMBERS VALVES *********************** APPLICATION: *All parts must be clean of all oils, dirt, or other debris. *Blast lightly with 120 grit al oxide or similar hard sharp material at low pressure *Degrease with a non-petroleum-based solvent. Allow to fully evaporate *After STIRRING and shaking apply coating. Spray at an air pressure of about 60 psi through a fine nozzle. *The coating has nearly the same appearance as the blasted part, so apply only enough to give a thin “wet” look to the part. *Allow drying to a “matte” finish. If humid use a fan or other tool to move air over the part to aid in drying. *Bake at a minimum of 300f for 1 hour. *Inspect part after curing for blisters, cracking, or flaking. The coating should have a slight gold tint. *DO NOT ASSEMBLE IF DAMAGE VISIBLE

 WARNING: Cancer – www.P65Warnings.ca.gov