ColorGard Black Exaust System Coating (CGBK)

Exhaust System Coatings

ColorGard Black Exaust System Coating (CGBK)

$147.90$448.37

SKU: CGBK Category:

Additional information

Weight N/A
Dimensions N/A
Sizes

Quart, Gallon

Exhaust System Coating

  • Black Semi-Gloss Finish
  • Thermal Barrier
  • Corrosion & Chemical Resistant
  • Substrate: +1800F; Environmental: +2000F
  • Low VOC
  • Full Cure: 700F for 1 hour.

APPLICATION: Sandblast all parts with 120 grit aluminum oxide. DO NOT USE GLASSBEAD. Clean metal using conventional cleaning methods, with acetone, lacquer thinner, or other similar non-petroleum-based solvents. When the surface is clean and dry, apply a thin even layer of coating using an airbrush, detailed touch-up gun, or other spray equipment that allows for the application of a thin film of approximately .001″ to .0015″. Avoid excessive build-up of material as this can lead to loss of adhesion. DO NOT APPLY A SECOND COAT AFTER THE COATING DRIES.
The coating will air dry to the touch in a few minutes.
You can do a partial cure at 500 degrees F, and cure the coating the rest of the way on the vehicle.
Install on the vehicle, as the coating will cure with exhaust heat, 700 for one hour.
CAUTION: Excessive exhaust heat due to a poorly tuned engine can damage the coating during the cure period. Do not install on a new engine until all adjustments have been made to the valves, timing, and jetting. Allow the engine to idle, or drive gently for approximately 30 minutes or until no vapor/smoke is given off by the coating. MAINTAIN adequate ventilation during this process.

CGBK MSDS MSDS

Additional charges may apply for Hazardous Material