ColorGard Clear Exhaust Coating<\/p>\n
For use with ColorGard line of products to make a glossy appearance<\/p>\n
APPLICATION: Sandblast all parts with 120 grit aluminum oxide. DO NOT USE GLASSBEAD. Clean metal using conventional cleaning methods, with acetone, lacquer thinner, or other similar non-petroleum-based solvents. When the surface is clean and dry, apply a thin even layer of coating using an airbrush, detailed touch-up gun, or other spray equipment that allows for the application of a thin film of approximately .001″ to .0015″. Avoid excessive build-up of material as this can lead to loss of adhesion. DO NOT APPLY A SECOND COAT AFTER THE COATING DRIES. The coating will air dry to the touch in a few minutes. Install on the vehicle, as the coating will cure with exhaust heat. For use with ColorGard line of products to make a glossy appearance<\/p>\n","protected":false},"featured_media":15,"comment_status":"open","ping_status":"closed","template":"","meta":{"_et_pb_use_builder":"","_et_pb_old_content":"","_et_gb_content_width":""},"product_cat":[16],"product_tag":[],"_links":{"self":[{"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/product\/48"}],"collection":[{"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/types\/product"}],"replies":[{"embeddable":true,"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/comments?post=48"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/media\/15"}],"wp:attachment":[{"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/media?parent=48"}],"wp:term":[{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/product_cat?post=48"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/techlinecoatings.net\/wp-json\/wp\/v2\/product_tag?post=48"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}
\nCAUTION: <\/b><\/span>Excessive exhaust heat due to a poorly tuned engine can damage the coating during the cure period. Do not install on a new engine until all adjustments have been made to the valves, timing, and jetting. Allow the engine to idle, or drive gently for approximately 30 minutes or until no vapor\/smoke is given off by the coating. MAINTAIN adequate ventilation during this process.<\/span><\/p>\n","protected":false},"excerpt":{"rendered":"