Insulating Barrier Coating

Floor Board. and Firewall Coating

Ready to spray no thinning needed
DO NOT THIN
STIR AND SHAKE WELL BEFORE USE
1. ALL PARTS MUST BE FREE OF OILS, GREASE,
MOISTURE, DUST, SCALE, OR CORROSION.
2. Clean all parts using acetone, M.E.K., or similar
material. DO NOT USE petroleum-based solvents.
3 . Apply coating by spraying or brushing. Apply one coat.
4. Allow to air dry for approximately two hrs. to touch,
24 hr. before use.
CLEAN UP: Clean equipment water.

DANGER: Contains solvent mixed with water.
Keep from heat, sparks, or open flame.

HEALTH HAZARD INFORMATION: Vapor is harmful. May cause eye
irritation, burning sensation on the skin. If inhaled, may cause headache,
dizziness, or nausea. Contains petroleum distillate, harmful or fatal
if swallowed.

Danger: Do not breathe vapors or mists from spraying. Avoid
contact with skin and eyes. Use adequate ventilation to maintain
exposure levels below established exposure limits (see MSDS). If required
wear an appropriate NIOSH-approved respirator with a paint prefilter.

READ DATA SHEET AND M.S.D.S. BEFORE USING

 WARNING: Cancer – www.P65Warnings.ca.gov