SPECIAL ORDER PRODUCT – PLEASE ALLOW ADDITIONAL PROCESSING TIME.
Additional information
Weight | 12 lbs |
---|---|
Dimensions | 8 × 8 × 8 in |
Size | Quart, Gallon |
SPECIAL ORDER PRODUCT – PLEASE ALLOW ADDITIONAL PROCESSING TIME.
- Appearance: Clear
- Thermal Barrier
- Corrosion & Chemical Resistant
- Substrate: 1300F
- Full Cure: 650 – 700F for 1 hour.
For more information, see data sheet and instructions.
APPLICATION: Sandblast all parts with 120 grit aluminum oxide. DO NOT USE GLASSBEAD. Clean metal using conventional cleaning methods, with acetone, lacquer thinner, or other similar non-petroleum based solvent. When the surface is clean and dry, apply a thin even layer of coating using an airbrush, detailed touch-up gun, or other spray equipment that allows for the application of a thin film of approximately .001″ to .0015″. Avoid excessive build-up of material as this can lead to loss of adhesion. DO NOT APPLY A SECOND COAT AFTER THE COATING DRIES. The coating will air dry to the touch in a few minutes. Install on the vehicle, as the coating will cure with exaust heat. CAUTION: Excessive exhaust heat due to a poorly tuned engine can damage the coating during the cure period. Do not install on a new engine until all adjustments have been made to the valves, timing, and jetting. Allow the engine to idle, or drive gently for approximately 30 minutes or until no vapor/smoke is given off by the coating. MAINTAIN adequate ventilation during this process.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Additional charges may apply for Hazardous Material